Exceptional HP ProLiant ML150 G6 DDR3 1333MHz ECC Registered DIMM memory upgrades

Increase the productivity of your HP ProLiant ML150 G6 server computing power by installing more memory. Trust PRO Memory Upgrade to provide beyond compatible expansion options for your server with a HP ProLiant ECC Registered DIMM RAM upgrade.

• Your HP ProLiant maximum RAM capacity: 48GB
• The ProLiant ML150 G6 has 12 memory slots or sockets
• This ProLiant module upgrade PIN count is: 240-PIN
• The memory speed is: DDR3 1333MHz, PC3-10600
• The server DIMM type for your ProLiant ML150 G6 is: RDIMM, ECC REG, ECC Registered DIMM

• For the HP ProLiant ML150 G6 server with twelve (12) memory slots
• There are three (3) channels per processor; six (6) channels per server
• There are two (2) DIMM slots for each memory channel; twelve (12) total slots
• Memory channel 1 consists of the two (2) DIMMs that are closest to the processor
• Memory channel 3 consists of the two (2) DIMMs that are furthest from the processor
• DIMM slots that are white should be populated first
• Do not mix Unbuffered memory (UDIMMs) with Registered memory (RDIMMs)
• Do not install DIMMs if the corresponding processor is not installed
• If only one processor is installed in a 2CPU system, only half of the DIMM slots are available
• To maximize performance, balance the total memory capacity between all installed processors
• It is not required, but it is recommended to load the channels similarly if possible
• You can only have up to eight (8) ranks installed per channel
• You can only install two quad-rank DIMMs per channel
• You can only install two UDIMMs per channel; if available, the third slot in the channel must remain empty
• Populate DIMMs from heaviest load (quad-rank) to lightest load (single-rank) within a channel
• Heaviest load (DIMM with most ranks) within a channel goes furthest from the chipset
• For memory mirroring mode, channel 3 must be unpopulated. Channels 1 and 2 are populated identically
• For lock-step mode, channel 3 must be unpopulated. DIMMs in channels 1 and 2 will be installed in pairs.
  The paired slots will be 1,4; 2,5; 3;6 on a 3DPC system or 1,4; 2,5; on a 2DPC system
• No mixing DIMM voltage; all DIMMs must be the same voltage